![]() This may prove to be stubborn fouling after a patient cleaning. There appears to be some light erosion in front of the chamber. Overall, the grips are in about Excellent condition.īore Condition: The bore is mostly bright, more gray immediately in front of the chamber. The grips have only a few light marks, the most notable at the bottom. Stock Configuration & Condition: The grips are two-piece checkered “Coltwood” plastic panels with large reinforcement rings at the grip screws and internal reinforcement ribs. The rear sight is a square notch dovetailed into the slide. Sights / Optics: The front sight is a short blade with the rear face serrated. The inside of the left grip panel has mold mark number “6” in the center of its reinforcing ribs, the right has “8”. The left of the barrel lug is marked “P” and the left of the chamber above the lug is marked “COLT 45 AUTO”, there is a small “F” on the bottom of the barrel forward of the link. The top of the frame is marked “G”, “Y” and “B” behind the disconnector. The left of the trigger guard is marked “K” and with “VP” in triangle, the right of the trigger guard is marked “70”. The right of the frame is marked “G.H.D.” above the trigger and “P” behind the magazine release. The right of the frame has an Ordnance wheel mark behind the top of the grip, “UNITED STATES PROPERTY / No 1117771” above and in front of the grip and “M1911A1 U.S. U.S.A.”, the bottom of the slide has inspector marks “U”, “G”, “V”, and “Z” by the right frame slot, the top of the slide is marked “P” between the rear sight and ejection port, the rear of the slide is marked “1117 / 771” under the firing pin retaining plate. 19.1913″ with a Rampant Colt and “COLT’S PT. Markings: The left side of the slide is marked PATENTED APR.20.1897. For this purpose it is modified with several holes drilled in the side, which are used to pin spacers in place to hold the smaller 9mm magazine in the standard 5.56mm magazine well.Action Type: Single Action Semi-Auto with Removable Magazine The full fence lower (both A1 and A2) is also the receiver used on Colt's 9mm SMG. ![]() However, due to the difficulty in identifying them from a distance and the fact that different manufacturers use slightly different designs (such as strengthening around only the front push pin or omitting the selector markings on the right side of the weapon), these have been treated as one variant for the purpose of identification. The design of this lower was upgraded with the adoption of the M16A2 featuring strengthening around the front and rear receiver push pins and fire selector marking on the right side of the receiver. It can be identified by the raised fence around the magazine release button on the right side of the weapon which is designed to lessen the chances of accidentally releasing the magazine. The full fence lower is the standard receiver used on all AR-15s since the M16A1. The preferred term for identification, be it the model name or simply the model number, is highlighted in bold.ģ.5" moderator (early) 4.25" moderator (late)Ĥ.25" moderator (Grenade ring) (early) A1 (late)ģrd gen. Due to the large number of companies that make AR-15 pattern rifles that are nearly indistinguishable from the original variants, all rifles should be identified using Colt terminology in the absences of any information to the contrary, such as unique parts or visible receiver markings. This is not a complete list of all variants produced by Colt, and only contains those variants that have appeared in media. This page is intended as a guide to identify the various Colt manufactured M16 variants and derivatives.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |